We congratulate your on buying a watch. This section will show you how to use the watch. Read the technical information and user's manual carefully. As it will help you to use the watch correctly.

TECHNICAL SPECIFICATIONS OF POLJOT MOVEMENTS

USER'S MANUAL

Your watch requires careful handing. If you want your watch work trouble-free and keep high accuracy, please, do the following:

- Wind the watch regularly once a day until full winding (except watches with automatic winding). Any manually wound watches work approximately from 35 up to 42 hours after full winding.
- Wear the watch with automatic winding on your wrist not less than 10 hours a day. Spontaneous movements of your hand make the rotor (oscillating weight) turn and thus winding the mainspring of the watch. If the watch is not put on for 38 hours it will stop. In order to make the watch go again, rotate set the time and the date.
- Protect the watch from falling and sharp shocks.
- Avoid exposing the watch to strong magnetic fields and chemical agents.
- Clean, lubricate and adjust as well as to check water impermeability of "water-resistant" watch once every two years after warranty is over.
- Do not open the case or remove its back cover: by that you protect your watch from unqualified service and entrance of dirt into the movement.
- Avoid exposing the watch to temperature extremes as that causes weeping of the crystal.

Accuracy of mechanical watches
Your mechanical watch does not need a battery. The watch can be repaired even after decades of its heavy usage. Mean daily rate at temperature +20(±5)°C ranges from -20 to +60 s/day depending on the movement type. More accurate parameters of mean daily rate you may find in the descriptions for each watch movement.

Hands setting
In order to set the hands, the crown should be pulled out from the case to the fixed position and then rotated clockwise to set the time.

Time-reading in the dark
Time can be easily read even in the full dark if marks denoting figures in the watch dial are covered with fluorescent colors.

WATER RESISTANCE

Level of water resistance and possibilities to use the watch correspond with the marking on the watch back cover.

- the watch without any marking on the back cover (common design) should be protected from water drops;
- "Water resistant" - you can wash yourself, when there is no splashing of water under pressure;
- "Water resistant 3 ATM" - you can wear the watch in rain and wash yourself under a faucet, when water is splashed up under small pressure;
- "Water resistant 5 ATM" - you can water your garden and wash your car with water coming out of a hose;
- "Water resistant (10 ATM)" - you can swim and dive (but not from a tower ) and to swim under water without a scuba.

Water resistant 5 and more atmospheres watch are as a rule equipped with screwed watch crowns. To set hands, wind up the watch, change the calendar setting or set a signal you should unscrew the screwed crown. Do not manipulate the watch winder under water.

CASE MATERIAL

Different materials are used to meet our customers wishes. Case material is denoted by the fourth figure in the number of the watch model.

3 - brass;
7 - titanium;
1 - stainless polished steel;
3 - sati polished steel.

Plating:

6 - gold plating;
9 - plating with rose gold;
1 - chrome plating;
1 - PNP-palladium and nickel plating.

CRYSTAL

Sapphire crystal protects from scratches (9 degree of hardness) and remains clear and undistorted for years of heavy usage. It is recommended for sport activities due to exceptional resistance and hardness of the crystal. However it can be broken if strongly stuck. Watches equipped with sapphire crystal have corresponding marking on the back watch cover.

Mineral crystal also remains clear and undistorted for a long time and it is also shock-resistant; but it is exposed to scratches.

TECHNICAL SPECIFICATIONS OF POLJOT MOVEMENTS